diff options
Diffstat (limited to 'vendor/golang.org/x/net/ipv4/doc.go')
| -rw-r--r-- | vendor/golang.org/x/net/ipv4/doc.go | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/vendor/golang.org/x/net/ipv4/doc.go b/vendor/golang.org/x/net/ipv4/doc.go index b4ce40fbc..b43935a5a 100644 --- a/vendor/golang.org/x/net/ipv4/doc.go +++ b/vendor/golang.org/x/net/ipv4/doc.go @@ -21,7 +21,7 @@ // // The options for unicasting are available for net.TCPConn, // net.UDPConn and net.IPConn which are created as network connections -// that use the IPv4 transport. When a single TCP connection carrying +// that use the IPv4 transport. When a single TCP connection carrying // a data flow of multiple packets needs to indicate the flow is // important, Conn is used to set the type-of-service field on the // IPv4 header for each packet. @@ -56,7 +56,7 @@ // // The options for multicasting are available for net.UDPConn and // net.IPconn which are created as network connections that use the -// IPv4 transport. A few network facilities must be prepared before +// IPv4 transport. A few network facilities must be prepared before // you begin multicasting, at a minimum joining network interfaces and // multicast groups. // @@ -80,7 +80,7 @@ // defer c.Close() // // Second, the application joins multicast groups, starts listening to -// the groups on the specified network interfaces. Note that the +// the groups on the specified network interfaces. Note that the // service port for transport layer protocol does not matter with this // operation as joining groups affects only network and link layer // protocols, such as IPv4 and Ethernet. @@ -94,7 +94,7 @@ // } // // The application might set per packet control message transmissions -// between the protocol stack within the kernel. When the application +// between the protocol stack within the kernel. When the application // needs a destination address on an incoming packet, // SetControlMessage of PacketConn is used to enable control message // transmissions. @@ -145,7 +145,7 @@ // More multicasting // // An application that uses PacketConn or RawConn may join multiple -// multicast groups. For example, a UDP listener with port 1024 might +// multicast groups. For example, a UDP listener with port 1024 might // join two different groups across over two different network // interfaces by using: // @@ -166,7 +166,7 @@ // } // // It is possible for multiple UDP listeners that listen on the same -// UDP port to join the same multicast group. The net package will +// UDP port to join the same multicast group. The net package will // provide a socket that listens to a wildcard address with reusable // UDP port when an appropriate multicast address prefix is passed to // the net.ListenPacket or net.ListenUDP. |